Getting to know your Mylo Soft Bi-Color LED Light
Precautions:
Keep the fixture away from water and all flammable gasses or liquids
Use only the recommended batteries
Handle unit with care
DO NOT attempt to disassemble or repair the unit without first contacting the service department at ikancorp.com
Keep the unit clean and free of dust, it can be cleaned with a soft, dry cloth
Use only parts provided by the manufacturer
ALWAYS use caution when plugging in the fixture
Mounting the Mylo Soft to a Stand:
The Mylo Soft comes with pre-installed yoke and combo mount. This allows the fixture to easily sit and adjust on any stand.
The yoke allows the light to move freely without obstruction. The Baby 5/8” and Junior1 1/8” Combo Pin gives the user a wide
range of stand options. The light can be mounted horizontally or vertically.
Power the LEDs:
The Mylo Soft light comes with an AC power supply and 6 foot cable. This allows the user to plug into any standard 120-240V
electronic outlet. The Mylo Soft can be powered from one of two Sony “L” Series Style Batteries that are supplied with the unit.
Adjusting the Color & Brightness of the Light:
The Mylo Soft is controlled by the large yellow knob on the rear of the fixture. The knob was designed with the idea that it could
be reached and adjusted when the light is up on the stand. The knob has two push settings.
1. The default setting is the brightness from 10-100% brightness.
2. By pressing in on the knob, the color temperature can be adjusted from 3200K-5600K.
Mylo Battery Options:
The dual battery charger allows you to charge both batteries at the same time.
Connect the power cable to the AC charger and plug it into a wall.
1. Place one or both battery packs into the charger and slide it towards the indicator lights.
2. The indicator lights will illuminate with how much charge is left on the battery.
3. The charger will begin charging once the battery is fully inserted into the charger. (Note: The battery is fully charged
when all lights are solid red.
Attaching the battery pack to the back of the Mylo Soft can be done by placing the battery against the back of the Mylo battery
port and sliding it forward.
Properly store the batteries when not in use. If the batteries will not be used for an extended period of time, run down the battery
and store it with the Mylo Soft.
