www.ikancorp.com | 1.713.272.8822 | [email protected]
because we’re
filmmakers
too
Ballast Installation Instructions
Connecting a fixture to the ballast and energizing the ballast with power.
Make sure the ballast and the lamp head fixture is compatible.
Check that the ballast is appropriate for the AC Power that will energize the ballast and fixture. (Voltage & Frequency)
The ballast needs to be properly grounded and the main power switch is in the OFF position.
The lamp with proper wattage is fitted into the head fixture.
Make sure the AC Power is not higher than the max power of the ballast.
The safety glass shield is in good working order with no cracks or anomalies. The safety glass is in the proper position and there is a safety wire guard.
Periodic Fixture Inspection
• The condition of the internal wiring and ceramic base will need to be inspected and tested every 4000 working hours or at least once a year. This
frequency may need to be increased if the fixture has endured rough treatment. All internal components should only be replaced with Lightstar
spare parts.
• The lamps should be checked every 100 working hours. The lamp should be changed if the lamp becomes deformed or damaged, otherwise
explosion might occur. Defer to instructions provided by the lamp manufacturer.
• Always check the safety shield before every use.
• All high-voltage components (Ex: Voltage wires, lamp ceramic, external shield, igniter must be inspected every 100 working hours or at least once a
year.
• Outer door hinges and latching system must be checked every 250 working hours. It must be replaced whenever it becomes either cracked or
broken. It is essential for the performance of the fixture.
Specifications
Fixture Specifications
Head Type
HMI Fresnel 6000W
Lens Type
Fresnel 16.5" Lens
Lamp Base
6000W/200V/G38
Beam Angle
6° - 58°
Control/Dimming
50%-100%
Focusing
Knob Control
Build Material
Aluminum
Cooling System
Air Cooled
Yoke
Cast Aluminum w/ 1 1/8
"
pin
IP Class
IP23
Fixture Size
36.6 x 27.5 x 24.2 in.
Fixture Weight
85 lbs
Electronic Ballast Specifications
Power Supply
Electronic Ballast 6000W
Input Voltage
180-250VAC
Electronic Ballast Size
14.2 x 10.2 x 17.7 in.
Electronic Ballast
Weight
50.7 lbs
Shipping Specifications
Shipping Dimensions Box 1
30 x 25 x 28 in.
Shipping Dimensions Box 2
24 x 15 x 25 in.
Shipping Weight
144 lbs
