ADJUSTMENT MODE
There are two different modes available to adjust the monitor as described below. The adjustment with ‘
o
’ in front
of the title are only available under User Mode. The adjustments with ‘
n
’ in front of the title are only available under
Factory Mode. You can perform the other adjustments by either User or Factory Mode. Please change the mode
as required.
USER MODE:
Turn ON the Power Switch and you are in the User Mode.
FACTORY MODE:
There are two ways to enter the Factory Mode.
1. Turn OFF the Power Switch. Connect the Iiyama short-connector to the RS connector on the PWB-
MAIN and set S1 switch on the PWB-RS of the short-connector to ADJ.MODE side. Turn ON the Power
Switch and you are in the Factory Mode. The following menu appears on the screen when you press the
MENU Button. Turn OFF the Power Switch and remove the short-connector from the RS connector to exit.
2. Turn ON and OFF the Power Switch while pressing the MENU Button. Turn ON the Power Switch again while
pressing the – Button and you are in the Factory Mode. The following menu appears on the screen when you
press the MENU Button. Turn OFF the Power Switch to exit.
The menu items in the Factory Mode are as follows:
Trapezoid
Parallelogram
Side-pin-balance
Side-pin-corner
Cushion-side
DEGAUSS
Uniform-VCENT
N-S RRC
DBF-Para
DBF-Phase
H-moire
H-convergence
V-convergence
Tilt-dy
Contrast
Brightness
V-size
V-position
H-size
H-position
Pin-cushion
Uniform-V-TB
Uniform-HCENT
Uniform-H-RL
Landing-TL
Landing-TR
Landing-BL
Landing-BR
- 2 -
RS connector
CRT
CRT face
PWB-MAIN
ADJ.MODE
E2PROM
S1
PWB-RS
Short-connector
V-linear-S
V-linear-C
Auto-da-test1
Auto-da-test2
Auto-da-test3
*
CRT Check
DF DP
*
Auto-da-test3 helps you to perform H/V-BLANKING and H/V-CONVERGENCE confirmations in this
SET-UP ADJUSTMENTS. The following items are displayed automatically in turn.
1. H/V-convergence
è
2. Tilt-dy
è
3. N-S RRC
è
4. Landing-TL/TR/BL/BR
è
5. H/V-blanking