- 5 -
1-9. PICTURE SIZE, POSITION AND DISTORTION adjustment (Criteria)
1)
2)
3)
Receive a cross-hatch inverted signal of MODE 5.
Adjust the picture size and position to the specified setting below.
Correct the side distortion with the front buttons so that X of the right hand
side figure is as follows: | X | </= 3.0mm.
H-size: 310±4mm
V-size: 232.5±4mm
H-position: | A–B |<4mm
V-position: | C–D |<4mm
1-10. PICTURE SIZE, POSITION AND DISTORTION adjustment
1)
2)
3)
Receive a cross-hatch inverted signal of all preset modes respectively.
Adjust the picture size and position roughly with the front buttons to the
reference settings below.
Correct the Pincushion and Trapezoid distortion with the front buttons so
that X of the right hand side figure is as follows: | X | </= 3.0 mm.
Bezel
A
B
C
D
Picture
Pincushion
Trapezoid
Pinbalance
Parallelogram
Side pin Top / Bottom
Pinbalance Top / Bottom
Notes: 1.
No other adjustment items for distortion than the above should
be adjusted.
2.
The picture should be within the bezel.
1-11. RESET confirmation
1)
2)
3)
4)
Receive a cross-hatch inverted signal of MODE 5.
Change the horizontal position (H-Position) roughly with the front buttons.
Perform Reset.
Confirm that the adjustment data above is reset to the factory setting.
n
n
H-size: 310±10mm
V-size: 232.5±10mm
H-position: | A–B |<8mm
V-position: | C–D |<8mm
o
Pincushion
Trapezoid
Parallelogram
Side pin Top / Bottom
Pinbalance
Side pin Top / Bottom
X
X
X
X
Pinbalance Top / Bottom
