Iiyama ProLite T3234MSC, User Manual

Page: 15 / 32

ENGLISH
BEFORE YOU OPERATE THE MONITOR 11

Procedure for turning ON the Power Switch
Turn ON the monitor fi rst, and then the computer.

Touch screen driver software
Touch screen driver software and system may not start when you start your computer while
touching the screen.
Touch screen driver software may not run due to the power saving function depending on the
BIOS of your computer. In this case, set the power saving function to off.

Signal Timing
Change to the desired signal timing listed on page 28: COMPLIANT TIMING.

Windows XP/Vista/7/8/8.1/10 Plug & Play
The iiyama LCD monitor complies with DDC2B of VESA standard. The Plug & Play function runs
on Windows XP/Vista/7/8/8.1/10 by connecting the monitor to DDC2B compliant computer with
the Signal Cable supplied.
For installation on Windows XP: The monitor Information File for iiyama monitors may be
necessary for your computer and obtained via the Internet, using the address:
http://www.iiyama.com

For additional information on how to download the driver for your touch screen monitor,
please access the internet site noted above.

Monitor Drivers are not required in most cases for Macintosh or Unix operating
systems. For further information, please contact your computer dealer fi rst for advice.
COMPUTER SETTING
NOTE
NOTE

Calibration Tool Install (This tool in the attached Touch Panel Driver Disk)
When using the monitor for the fi rst time, install tool without fail, and please execute calibration tool.
1. Open the Touch Panel Driver Disk (CD-ROM).
2. Select ProLite MSC/MC series.
3. Click 32".
4. Please clcik Calibration to start it.
Do not touch the screen during executing calibration tool.
5. After a few seconds, calibration is completed and "Calibration OK" message is displayed.
6. Exit to close the calibration tool.