Ihse Kvm-Tec masterEASY, Manual

Page: 24 / 87

24 | kvm-tec
2. INSTALLATION OF THE EXTENDER
2.2. MOUNTING OPTIONS
2.2.1 MOUNTING PADS AND RUBBER FEET
The mounting pads and rubber feet can be used to hold the extenders in place and prevents
them from sliding and falling.
To attach the mounting pads or rubber feet:
1. Remove the protection layer from the mounting pads or rubber feet (G).
2. Attach the mounting pads or rubber feet (G) to the bottom the units.
2.2.2 MOUNTING KITS (OPTIONAL)
The following mounting kits are available:
Rackmounting RMK-EASY-F Part Nr. 6232 RMK-EASY-F
The rack mounting kit RMK-EASY- F is for mounting kvm-tec smartEASY single and dual
extenders. It consists of a19“ rack shelf and an alu-faceplate.
Rackmounting RMK- EASY- FN - T Part-Nr. 6232 RMK- EASY-FN
The rack mounting kit RMK-EASY-FN is for assembling kvm-tec smartEASY extenders. It consists
of 19“ Rack Shelf, an alu-faceplate and a power supply. For 4 Single or dual Extender in one
Rack
Under table mounting kit Part Nr 6231 UMK EASY
The Under Desk Mounting kit is for underdesk mounting of the MX extender.
Din Rail mounting Part-Nr. 6235 DINMK- EASY
The DIN rail mounting is used for space-saving installation in control cabinets or on DIN rails.
The attachment to the smartEASY Extenders is possible in several ways.
Vesa mounting Part-Nr. 6236 VH-EASY
The robust VESA mounting is used to attach an extender to a monitor with existing VESA
mounting points. The Extender becomes one unit with the monitor and saves a lot of space
and cable clutter.
.