Installation
Draco vario
DisplayPort
1.2
68
6.1.2 Setting up an Add-on Module
The add-on modules can be hot plugged.
Add-on Module Analog Audio/Serial RS232
1. Connect the audio source to the CPU Unit (e.g., computer audio OUT with CPU Unit audio IN,
computer audio IN with CPU Unit audio OUT).
2. Connect the audio OUT on the CON Unit to headphones or suitable speakers.
3. Connect the audio IN on the CON Unit to a suitable microphone.
Add-on Module Serial RS422
1. Connect the CPU to the CPU Unit by using the serial cable.
2. Connect the CON Unit to the serial connector of the input device.
Add-on Module Digital Audio
1. Connect the digital audio source to the audio input of the CPU Unit.
2. Connect the audio output of the CON Unit to suitable speakers or audio amplifiers.
If several active sources are connected, Mini-XLR input takes priority.
The audio signal is available at all outputs.
Add-on Module Balanced Audio
1. Connect the balanced audio source to the appropriate audio input of the CPU Unit.
2. Connect the audio output of the CON Unit to suitable speakers or audio amplifiers.
Add-on Module USB-HID
1. Connect the source to the CPU Unit (USB-HID port).
2. Connect the USB-HID devices to the CON Unit (USB-HID ports).
Add-on Module PS/2
1. Connect the source to a CPU Unit (PS/2 ports).
2. Connect the PS/2 devices to the CON Unit (PS/2 ports).
Add-on Module USB 2.0 embedded
1. Connect the source to the CPU Unit (USB 2.0 port).
2. Connect the USB 2.0 devices to the CON Unit (USB 2.0 ports).
Add-on Module USB 2.0
1. Connect the CPU to the CPU Unit (USB 2.0).
2. Connect the USB 2.0 devices to the CON Unit (Connect to USB 2.0 devices).