SuperiorFireplaces.us.com
900855-00_C
18
Figure 37 - Installing Masonry Brick Side and Rear Panels
Figure 36 - Hearth Brick Panel
Fireplace models WRT4038IS, WRT4038IH, WRT4043IS and
WRT4043IH, contain a masonry brick hearth, sides and back. The
masonry brick hearth is factory mounted, the back and sides are
strapped to the back and sides of fireplace. These masonry brick pan-
els are reinforced with steel, but can be broken by improper use. The
masonry brick panels may easily be replaced. Follow the instructions
below for installation of sides and rear masonry brick panels or when
replacing entire kit.
IMPORTANT: Installation of masonry brick panels
should be done after the fireplace is placed in a
permanent location.
Note:
Remove grate, screen assemblies and all hardware components
out of the box prior to installation.
INSTALLATION
1. Make sure masonry brick hearth panel is centered in the firebox
and flush with the front of the fireplace. Be careful not to pinch
your fingers between the panel and firebox (Figure 36).
Note:
If
replacing entire kit, start with the masonry brick hearth panel,
then follow steps below.
2. Install the left and right masonry brick panels, align flush with
front cover plates and secure them with retaining brackets and
screws (provided), see Figures 36 and 37.
3. Place the provided grate retainers on the masonry brick hearth
as shown in Figure 37 and refer to Figure 33, page 17 for cor-
rect distance.
4. Install the rear masonry brick panel last. Place the rear masonry
brick panel against the back of firebox align flush with left and
right masonry brick panels and secure with retaining brackets
and screws (provided) see Figure 37.
Note:
Install grate, screen assemblies and all hardware components
into the firebox following steps in reverse from Refractory Panel
Installation, page 17.
MASONRY BRICK PANEL INSTALLATION
Retaining
Bracket
Grate Retainer
Left Masonry
Brick Panel
Masonry
Brick
Hearth
Panel
Front
Cover
Plate
Rear Masonry
Brick Panel
Right Masonry
Brick Panel
