2
Printed in U.S.A. © 2008 IhP LLC
P/N 775291M REV. B 11/2013
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.
IHP reserves the right to make changes at any time, without notice, in design, materials,
specifications, prices and also to discontinue colors, styles and products. Consult your local
distributor for fireplace code information.
1508 Elm Hill Pike, Suite 108 • Nashville, TN 37210
Figure 3
Step 4. Put trim in place by inserting trim studs into the corresponding
holes in the door (see Figure 2
)
. The top piece of trim will only fit
in one direction, but the bottom piece can be installed incorrectly.
When placing the bottom piece of trim make sure there is a small
gap between the bottom of the trim piece and the bottom of the
door, if the trim extends below the bottom of the door the trim is
on upside down.
Step 5. Place one washer on each stud (see Figure 2
)
. Using a 5/16”
nut driver, snug up the nuts on each piece of trim. Do not finish
tightening nuts.
Step 6. There should be approximately a 1/8” gap between the edge of
the trim and the top and bottom of edges of the door. Visually
inspect the alignment of the trim and adjust if necessary.
Step 7. Finish tightening nuts. CAUtION - DO NOt OVERtIGhtEN
NUtS.
Figure 2
COMPLEtED
INStALLAtION
Step 8. Close the front door and secure latches (see Figure 1
)
. Close left
side panel door. Use a household glass cleaner or alcohol and
a soft cloth to remove any fingerprints from all plated surfaces
prior to firing the stove. Read Caution on Page 1.
