Step 16
. Turn on gas supply and test for gas leaks using a gas leak test
solution (see
Test Procedure
on Page 18 of the
Installation and
Operation Manual).
Step 17.
Using a manometer, test the inlet and manifold gas pressure
per instructions in the Installation and Operation Manual (Page
18
)
and as shown in the following 2 tables.
Step 14.
Reinstall the log set and glass door assembly. See Page 12
(Log Set Installation)
and
Page 25
(Door Assembly Installation)
in the
Installation and Operation Manual
.
Step 15.
Light the appliance per the lighting instructions label on ap-
pliance (located below glass door) or lighting instructions on
Page 19 of the
Installation and Operation Manual
. Inspect for
proper pilot and burner flame appearances (see Figures 14
and
15 below). Also see
Flame Color and Behavior
and
Inspect The
Pilot System For Proper Flame
on
Page 20 of the
Installation
and Operation Manual
.
Figure 15 - Burner Flame Appearance
No Blue Flame
Center
Soot at
Flame Tip
Dark Orange
Flame
IMprOpErLy
BurNING FLaME
Soot above
Flame Tip
No Soot at
Flame Tip
prOpErLy
BurNING FLaME
Semi-Transparent
yellow Flame
Blue Flame
Center
ports on pan
Burner assembly
Figure 14 - Proper Pilot Flame Appearance
Safety Label
Step 15.
Use the sticker that reads “Epic LP 39” to cover model “Epic
NG 40” on the label if orifice #49 is installed. Use the sticker
“Epic LP 31” to cover “Epic NG 40” on the label if orifice #52
is installed. The label is located on the inside of the left hand
door (see Figure 14
)
.
Figure 12
Figure 13
Inlet Gas Supply pressure
Fuel #
Minimum
Maximum
Desired
propane
11" wC/po. C.E
(2.74 kpa)
13.0" wC/po. C.E
(3.23 kpa)
11" wC/po. C.E
(2.74 kpa)
Manifold Gas Supply pressure
Fuel #
Low
high
propane
(Lo) 6" wC/po. C.E
(1.50 kpa)
(hi) 10.0" wC/po. C.E
(2.49 kpa)
Step 14.
Before you secure the burner with screws, double check that
the orifice is positioned into the burner neck by feeling around
the back of the burner (see Figure 12
)
. Then, lower the burner
so it sits flush on the burner supports and replace the 2 screws
removed in step 6 (see Figure 12
)
.
reach behind burner and feel orifice to
ensure it is centered in the burner neck
Lower burner flush and reinstall
screws (indicated by arrows)
Burner
Burner
4
printed in u.S.a. © 2007 Ihp LLC
p/N 775244M rev. C 12/2013
IHP reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local dis-
tributor for fireplace code information.
Innovative hearth products
1508 Elm Hill Pike, Suite 108 • Nashville, TN 37210
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.
f i r e - p a r t s . c o m
