Astria.us.com
126753-01M
17
Spring
Clip
Hold-Down
Screw
Side
Front
Face
Partially
Opened
Door
Spring Clip
Press
Spring Clip
to Release
Pivot Pin
Remove Bottom Pin From
Pivot Plate While Sliding Door
Out of the Upper Track
Pivot Plate
Fold Bi-Fold
Door After
Releasing
Spring Clip
and Slide
Door Out of
Upper Track
CLOSE
OPEN
VENT DAMPER MUST BE LOCKED
IN THE FULL OPEN POSITION
TO OPERATE THE APPLIANCE
6. Repeat the process for the opposite door assembly.
7. To adjust doors, slide them partially open. Using a screwdriver,
loosen hold-down screws in the spring clip
(see
Figure 33
)
and
pivot plate.
8. Close both doors until evenly joined at the middle and note the
gap at outer edges of face.
9. Reopen one door at a time and retighten upper and lower hold-
down screws.
10. Repeat process until both doors are evenly joined, spaced and
working freely.
CAUTION: The glass panels become very hot while
the appliance is operating. Do not attempt to adjust
or clean the glass doors until the appliance has fully
cooled.
The doors may be removed for replacement or cleaning as follows:
1. Partially open door and press up on upper spring clip with a screw
driver until outer top pivot pin is free of clip.
2. Fully fold frame assembly and slide upper edge towards center of
firebox opening until guide pins are free of frame rail
(see
Figure
34
).
CAUTION: Always operate the appliance with the
doors either fully opened or fully closed. Operating the
appliance with the doors partially open can result in
improper venting of flue products.
WARNING: Discontinue use of the appliance imme-
diately if doors are damaged and contact a qualified
installer for repair. Only doors certified with the ap-
pliance shall be used.
WARNING: Do not slam or strike doors. Damage
can result in a hazardous condition.
INSTALLATION
Continued
OPENING VENT DAMPER
Vent damper must be locked in the full open position before operating
fireplace. If vent damper is not open, fireplace will not light.
Figure 33 - Adjusting Glass Doors
Figure 34 - Removing Glass Doors
Figure 35 - Opening Vent Damper
