IHOS NAXOS Series, User Manual

Page: 10 / 16

4. Slowly increase the level control of the corresponding MIC/LINE inputs. You should hear music
from the Loudspeaker.
1. Using the relevant cable, such devices can be connected by wire to any of the NAXOS
mini jack to mini jack stereo cable.
2. Connect one end of the mini jack cable to your desired device and the other end to the Aux
input of the NAXOS Loudspeaker.
3. After ensuring that there is music playing on your device and that its volume is not set to
minimum, slowly increase the BT/AUX, you should hear music from the Loudspeaker.
1. Ensure that the Bluetooth on your chosen host device is turned on.
2. On your NAXOS Loudspeaker, long press the Pair button for 2 seconds, the Pair blue LED should
NAXOS
NAXOS 10A DSP,NAXOS 12A DSP
,NAXOS 15A DSP
begin to flash rapidly.
4. Once the connection has been established, the Pair blue LED of the Loudspeaker will remain lit
continuously to indicate a successful connection.
5. Ensure that your host device is playing music and that its volume is not set to minimum.
6. When slowly increasing the level of the BT/AUX control of the Loudspeaker you should hear
your source music.
When connecting your host device to a single NAXOS loudspeaker using Bluetooth, both the left and
right channels of a stereo signal will be combined and played through the single Loudspeaker.
However, using two NAXOS Loudspeakers, the TWS function allows them both to be connected
wirelessly as a stereo pair to the same host Bluetooth device as described below. This assumes
that both Loudspeakers have been connected to AC power and are switched on.
Note: The NAXOS Loudspeaker first paired to your host device will become the Left stereo speaker.
1. Pair and connect the first NAXOS Loudspeaker to your host device as described in the previous
paragraph (connecting via Bluetooth). This will become the Left speaker.