Trouble Shooting
6
P10
Symptom
Possible Problem Solution
Unit doesn’t respond
(no power)
AC adaptor isn’t plugged into a wall outlet
or the connector is not plugged into the
power supply jack on the back of the dock
Plug the AC adaptor into a wall outlet and plug the
connector into the supply jack on the unit
Wall outlet is not functioning or switched off
Plug another device into the same outlet to confirm the outlet
is working. Make sure any associated power switch is ON
iPod/iPhone does not
dock properly
iPod/iPhone not docked properly
Remove your iPod/iPhone from the dock and check for
obstruction on the connectors in the dock and on your
iPod/iPhone. Make sure there is no “skin” or case on the
iPod/iPhone. Then reseat it in the dock.
iPod/iPhone does
not respond to the
unit
iPod/iPhone is not docked properly
Remove your iPod/iPhone from the dock and check for
obstruction on the connectors in the dock and on your
iPod. Then reseat it in the dock.
Your iPod/iPhone software is too old
Upgrade software on your iPod/iPhone via iTunes
iPod/iPhone is locked up
Please make sure your iPod/iPhone is working properly
before docking into the unit. Please refer to your
iPod/iPhone manual for details.
Using 1
st
or 2
nd
generation iPod, iPod
shuffle or other devices.
Unit cannot control those iPod models or other devices.
Use the Line-in jack to play these devices.
Battery is weak/ dead
Charge internal battery by connecting AC adaptor to
working outlet until battery indicator glows steadily.
If your iPod/iPhone is not used for some
time, it may enter deep sleep mode
iPod/iPhone battery is run down or is too
weak
Unit requires reset
Press the Menu button on your iPod/iPhone
Charge your iPod/iPhone for about 5 minutes
Insert the end of a paperclip or similiar into the Reset port
located next to the AC jack and press in for a few seconds
to restore the unit to factory default settings. Doing so will
overwrite any current settings.
iPod/iPhone does not
come on immediately
Unit operation is erratic
Remote control
doesn’t work
Battery is weak or dead
Remote Control is too far away or not
aimed properly toward the device
Remote switch is in AUTO position
Replace with new battery
Point the Remote Control toward the unit and use within 15 feet
of the unit.
Move Remote switch to ON position
