Installation and Maintenance
Installation
1. Remove the unit and all packing material from the carton. You should save packing materials in case unit needs to be
return for service. If you do not wish to save the materials, please dispose of them properly.
2. Place the unit on a stable, level surface, close to an AC outlet, out of direct sunlight, and away from sources of dust,
dirt, heat, water, moistures, vibration and strong magnetic fields.
3. After installing the batteries (see below) and reading the Maintenance notes, plug the AC cord into an outlet.
“Sure Alarm” Battery Backup Installation
It is recommended that 2 “AA” (LR6) batteries be installed into the unit, as directed below, to
activate the “Sure Alarm” battery backup feature. In the event that the AC power cord is
disconnected or a power failure or other interruption occurs, the “Sure Alarm” system will maintain
clock and alarm settings for the life of the batteries, ensuring that the alarm will sound at the set
time (Note: while operating on battery power, all set alarms will sound as a buzzer). When power is
restored, the clock will cease using battery power, and will again operate on AC power. The Battery
Low Indicator flashes when there is not enough power to run the backup.
1. Use a Phillips screwdriver to remove the battery compartment door.
2. Install 2 “AA” (LR6) batteries (alkaline batteries are recommended for longer life) into the battery
compartment, making sure that the + and – polarities match up with the diagram printed inside
the compartment.
3. Close the battery compartment door and tighten the screw. Gently return the clock radio to its
upright position.
Maintenance
1. Place the unit on a level surface away from sources of direct sunlight or excessive heat.
2. Protect your furniture when placing your unit on a natural wood and lacquered finish. A cloth or other protective material
should be placed between it and the furniture.
3. Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents, such as Benzene,
thinner or similar materials can mar the surface of the case.
4. If the unit is not to be used for a prolonged period, such as a month or longer, remove the batteries to prevent possible
corrosion. Should the battery compartment become corroded or dirty, clean the compartment thoroughly and replace
the batteries.
5
Rear Cover
Aux Input cord
FM Antenna
nano
Controls and Indicators
HiH60 Display
Power Button
Clock Adjust Button
Time Zone Button
Courtesy Outlet
Preset Lock Switch
DST Switch
Mode Button
Dock
Dock Adjust Dial
Radio Preset Button
Nature Sounds Button
Wake To Button
Alarm On/Off Button
Volume Thumbwheel
Button
Button
Music Button
Snooze/Dimmer Button
Alarm Set Button
AM/PM Indicator
Battery Low Indicator
Alarm Indicator
PM Indicator
am Indicator
AUX Indicator
FM Indicator
iPod Indicator
Clock Display
Time Zone/Radio Frequency/Date/Alarm Time Display
DST Indicator
Wake To Indicator
4
