19
Installation
Turning on the Power
O
After connecting your external equipment, turn on the
power of the unit.
Turning on the power
Turning on the power
1
Make sure that the standby indicator
on the front panel is lit in red, then
press
on the unit or
on the
remote control.
Make sure that the standby
indicator in standby mode.
Press
on the front
panel to turn on the
power.
The standby indicator is OFF and
the input indicator light is ON.
Press
on the
remote control to turn
on the power.
or
• This unit will automatically turn to standby mode if there is no
signal from selected input within ten minutes.
About the remote control’s operating
range
O
Point the remote control at the remote sensor on the
unit.
O
Avoid exposing the remote sensor to intense light. The
remote control may not function under such a condition.
O
Do not place obstacles in the path between the remote
control and remote sensor. Otherwise, the remote
control may not work or will respond slowly.
Remote sensor
Within about 16 ft (5 m)
About 30º About 30º
O
From the remote sensor:
Distance – Within 16 ft (5 m) / Angle – Within 30˚ (horizontal);
Within 20˚ (vertical)
Q
About the remote control
O
Do not drop, swing or apply impact to the remote control.
O
Do not splash water on the remote control or place it on a
wet object.
O
Do not disassemble the remote control.
O
Do not place the remote control in a place subject to high
temperature or humidity.
HAV-R100G_R200G_R300GT.indb 19
HAV-R100G_R200G_R300GT.indb 19
4/20/2012 11:58:15 AM
4/20/2012 11:58:15 AM