5019 100 01018
Programmes with prewash last about 15 minutes more than programmes without prewash. Water and energy
consumption values were measured in standard conditions in compliance with the Standard IEC 60 456. Individual
consumption may vary in comparison with the values specified in the table, because of differences in supply water
pressure and temperature, the load and the type of wash.
ADDING DETERGENT AND ADDITIVES
Pour the detergent and additives into the respective
compartments as follows:
•
Programme with pre and main wash
•
Main wash programme without prewash
•
Fabric softeners and starch
•
Stain removers
•
Anti-scale agents (water hardness 4)
Important Note:
•
Do not fill beyond the “MAX” level mark.
•
For programme with prewash: do not use liquid
detergent.
•
For programmes without prewash from cold to 40° C, it is recommended to use a liquid
detergent to avoid whitish residues on the coloured laundry.
CLOSE THE DOOR AND SELECT THE PROGRAMME
•
Turn the programme selector knob clockwise to the desired programme.
PRESS ANY DESIRED OPTION BUTTON(S)
“Half Load” button
•
Reduces the water consumption in the “Cotton” and “Synthetics” programmes
especially during the rinse.
•
Especially suitable for lightly soiled or small loads (reduces the quantity of detergent).
•
Not suitable for high temperature programmes.
PROGRAMME START
Open the water inlet tap and press the “On/Off” button. The pilot lamp lights up.
DOOR LOCK
During the running programme, the door cannot be opened.
The door locks automatically in all programmes.
If the programme is stopped or if an electrical power failure occurs, the door unlocks
automatically after about 1 minute.
PROGRAMME END
•
The programme selector knob is at “STOP”.
1.
Press the “On/Off” button. The pilot light goes out.
2.
Cancel the option by pressing the appropriate button.
3.
Turn the water supply tap off.
4.
Wait for the door to unlock (about 1 minute).
5.
Open the door and the drum flaps and unload the machine.
SELECTING A NEW PROGRAMME, SPIN SPEED, OPTIONS AFTER
PROGRAMME START
1.
Press the “On/Off” button to switch off the appliance.
The pilot light goes out.
2.
Select the new programme and option.
3.
Press the “On/Off” button to switch on the appliance.
The pilot light lights.
TO STOP, RESET A PROGRAMME BEFORE THE END
1.
Press the “On/Off” button to switch off the appliance.
The pilot light goes out.
2.
Set the programme selector on “Drain”.
3.
Press the “On/Off” button to start the “Drain” programme.
Only open the door when the programme selector is at “STOP” and
the door is unlocked (after approximately 1 minute).
ENERGY AND WATER CONSUMPTION DATA
Programme
Temperature
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Programme
time
(min)
Cotton
90
4.5
69
1.75
115
Coloured Cotton
60
4.5
69
0.95
90
Synthetics
40
2.0
66
0.35
70
Delicate
40
1.5
70
0.65
55
Wool
40
1.0
70
0.55
45
GB
