L O A D E R
34
MRBP.424321.001G2 Version 1.0 15/06/2020
6)
press the button
and confirm the action, then wait software update completion.
Notice:
In case of controller power supply reset while program updating, it is neces-
sary to reenter the loader and restart software update.
Holding the button waiting time while entering the
«
Loader
»
increases up to
20-30 seconds.
In case of SD card absence, the following message is displayed:
SOFTWARE FILES:
SD CARD NOT FOUND!
10.2
CHANNELS AND CONTROLLER SETTINGS RESET TO FACTORY DEFAULTS
To reset all control unit EMI-SSD-1M settings to factory defaults it is necessary to enter
«
Loader
»
menu
→
«
RESET TO FACTORY DEFAULTS
».
RESET TO FACTORY DEFAULT
CANCEL
APPLY
WARNING! All settings of the channels
and controller will be reset to default!
In the
«
RESET TO FACTORY DEFAULTS
»
menu it is possible to apply channels and controller
factory defaults or cancel an action. The warning message is also displayed.
Factory defaults parameters are shown in Appendix B.