en
11
User manual MAX
www.igloo.pl
Fig.1 Structure of the device
1 – Manual roller
2 – Internal upper lighting
3 – Display shelves with adjustable height
and suspension angle
4 – Podstawa regału
5 –Wooden Platform used for the
transportation of the device
6 – Feet used for leveling the device
7 – Control panel (thermostat/switches)
8 – ABS sides
9 – Front screen
10 – Rack screen (DO NOT BLOCK THE
VENTILATION
HOLES providing the circulation of the cooled
air!)
11 – Nameplate
2.3. Technical data
Table 1 Technical data
Type of
the device
„MAX”
Rated
voltage [V/Hz]
Rated
current [A]
Rated
lighting
power[W]
Electric energy
consumption
[kWh/24h]
Max obciąż. półki
[kg/shelve]
Weight of
the device
[kg]
230/50
1,9
6
6,1
15
75
The device may be actuated solely after confirmation of the fire protection efficiency with results of measu
-
res performed according to binding regulations!
3. PREPARING THE DEVICE FOR EXPLOITATION
3.1. Requirements concerning the place of installation
• Verify whether the cross section of feeding conduits is proper for power consumption of the installed device.
• It is forbidden to connect the device by extension rods or dividers.
• The device should be connected to the separate, properly made electric circuit with plug-in socket with protecting pin
(according to PBUE /Regulations concerning Electric Equipment Construction/)
3.2. Connection and actuation
•
Unpack the device and remove the wooden platform from the basis (does not concern moving devices) Fig.2 (p.17
•
Remove the protection foil from the elements of the device (f. ex. from the inside of the device, display shelves,
•
front fender beam)
•
The first cleaning of the device
should be provide right after unpacking, and before turning it on. The unit should
be cleaned with water at a temperature not exceeding 40°C with a neutral detergent. For washing and cleaning the
equipment it is prohibited to use products containing chlorine and sodium varieties, which destroy the protective
layer and components of the device! Any residue of adhesives or silicone on metal elements should be removed
only with extraction naphtha (not applicable to items made of plastic !). Do not use other organic solvents.
When cleaning the unit is prohibited to use water jet. The unit should be cleaned with a wet rag.
After installation of the device at the destination place it should be left to rest for at least 2 hours before
turning it on (for devices with built in compressor) to set the level of refrigerant in order to prevent pro
-
blems with starting up the aggregate.
WARNING: Keep out the cooling circuit from damage!
