en
17
User manual BASIA M
www.igloo.pl
Rys.6
Montaż elementów szklanych i lampy aluminiowej
During maintenance services it is necessary to pay attention not to damage the data plate of
the device Fig.11 (p.18), which contains significant information for servicing organs and waste
removal companies.
6. SERVICE
6.1. Fault identification and repair
In case of any difficulties during actuation of the device or during its exploitation, please return to these chapters in this
manual, which explain the performed operation. This aims to ensure that the device is properly operated. If you still
experience difficulties, the following hints will help you solve the problem.
The device is not working... – Make sure that:
• The device is connected to the supply network
• Voltage and frequency in the network are compliant with those recommended by the producer 230V/50Hz
• The main switch is turned on
• Thermostat is switched on (Concerns the Igloo thermostat – If only two dots are displayed on the screen – turn on
the thermostat)
The device is operating, the lighting is switched off... – Make sure that:
• The lighting switch is on
• Fluorescent lamp or the starter of the device are not blown out
The device does not reach the proper temperature, the lighting is on...– Make sure that:
• The main switch is on (position 1)
• Temperature setting on the thermostat is properly set
• The thermostat is operating properly
• Make sure that the condenser is not filthy, and clean the condenser when necessary
• Ambient temperature does not exceed 25ºC
• Enough time has passed for products to be cooled
• Ventilation holes of the device are not blocked
(This concerns the “IGLOO” thermostat) The regulator displays C0 or C1 or C2 instead of displaying temperature:
This situation shall occur, when one of temperature regulation sensors has been destroyed.
The following messages may be displayed in such case:
• C0 – temperature sensors inside the chamber are damaged – call authorized service
• C1 – failure of evaporator sensor - call authorized service
• C2 – failure of condenser alarm sensors (or failure of second evaporator sensor) – call authorized service
Fig.10 Exchange of the
fluorescent lamp
1 – Grip of the fluorescent lamp
2 – Fluorescent lamp
3 – Casing of the fluorescent
lamp and the starter
4 – Starter of the fluorescent
lamp
Elements of device can corrode when improper used and maintenance. To avoid that please
follow the rules:
• Do not allow contact of the surface of the device with substances containing chlorine and / or baking
soda in different varieties, which destroy the protective layer and components of the device (also
includes various stainless steel)
3
4
2
1
