IGF 2000, Manual For Use And Maintenance, Page: 17 / 32

page 17
3) How to use the lava rock barbecue
In order to achieve good results without causing any damage to the lava rock
barbecue, it is necessary to switch on the necessary burners following the
Instructions for Use, paragraphs 1, 2. Once the burners are switched on, bring
the knob to the position of maximum power, marked by the symbol 1 (one)
and keep it in that position for not more than 6 (six) minutes.
Then bring the knob to the position of minimum power marked by the symbol
½ (a half) and keep it in that position for other 6 (six) minutes.
At this point the right temperature has been reached and it is possible to start
the cooking.
During cooking, the knob must always rest in the position of minimum power
marked by the symbol
½ (a half).
At the end of cooking, bring the knob back to the “off” position marked by the
symbol
0 (zero) and always remember to close the gas tap or the cylinder tap.
INSTALLATION AND OPERATION
The installation must be performed by qualified technicians and
always in compliance with the manufacturer’s instructions. A wrong
installation may cause damage to people, animals and things. The
non compliance with the installation procedure may lead to damage to the
Equipment. The manufacturer disclaims responsibility for any damage caused
to the Equipment or to people, animals and thing due to an installation
procedure which was not carried out in accordance with the manufacturer’s
instructions. It is strictly forbidden to use the machine to perform different
functions from those described in the manual and to introduce any change to
the machine without the approval of the manufacturer.
1) After the lava rock barbecue has been assembled and before its installation,
ensure that the type of gas supply corresponds to the type indicated in the
identification plate, placed in the machine.
2) If the gas supplied, either by a gas main or by a gas cylinder, is L.P.G it is
necessary to install a pressure reducer by the outlet of the gas supply, so that
the gas outlet pressure corresponds to the pressure of the methane supply
system of the Country where the Machine is installed.
Connect the lava rock barbecue on the gas feeling trough the pliable
approved tube, present with the apparatus.
When the machine is working, the pressures of the gas supply, measured in
Pascal, and consequently the outlet pressures of gas taps, which are made
equal by means of a pressure reducer, differ according to some of the
Countries where the lava rock barbecue is sold. These pressures are
indicated in the following table:
Â