7
MAINS PLUG FUSE REPLACEMENT
(Class II)
Remove the central screw on the plug and open the shell.
Take out the fuse and replace with a new fuse of the same
Amp. Install the shell again and tighten the screws.
TROUBLE SHOOTING
Please refer to the trouble shooting guide when experiencing an issue with your heater. If you still cannot
determine the fault then please call our Customer Services number 01473 271272
Problem
Possible Cause
Solution
The heater does
not work.
1. Not properly plugged into the
mains wall socket.
Push plug firmly in.
2. Not switched on.
The heater is
getting too hot.
Confirm the unit is switched on.
3. Power cut.
Adjust the temperature control.
The heater is
not heating up.
1. Temperature control set too low.
Check the fuse or breaker.
1. Inadequate air flow.
2. Temperature control set to high.
3. Power cut.
Make sure there is air circulating
in the room.
Make sure that nothing is blocking
the air flow.
Adjust the temperature control
to a higher setting.
2. The Mode selector is on
the wrong mode.
Turn the Mode selector to
ll high mode.
