Door Fitting
The Refrigerator door can be fitted to open either to the right or to the left, depending on its
location. The refrigerator is delivered to you with the door opening from the left hand side. To
change the opening direction please follow these instructions.
•
Turn off the power.
•
Remove the top hinge cover (Fig 1).
•
Remove the three screws (Fig 2 & 9) that hold the top hinge (right side) to the
frame. Take away the top door hinge (Fig 3).
•
Lift the door (Fig 4) and place it carefully onto a padded surface to prevent
scratching.
•
Remove the top hinge screw cap (Fig 5), hinge plug (Fig 6), levelling front legs (Fig
7 & 8), bolt (Fig 9) and bottom hinge (Fig 10).
•
Change the placement of the corresponding parts.
•
Fix the top hinge screw cap (Fig 5), hinge plug (Fig 6), levelling front leg (Fig 7) to
the corresponding position on the right hand side.
•
Fix the levelling front leg (Fig 8), bolt (Fig 9) and bottom hinge (Fig 10) to the
corresponding position on the left hand side.
•
Set the door (Fig 4) in its place making sure it sits on the bottom hinge.
•
While holding the door in the closed position, secure the top hinge (Fig 3) on the
top left hand side with the three screws. Do not tighten the three screws until the
top of the door is levelled.
•
Install the top hinge cap (Fig 1) on the top hinge.
3
Cleaning Before Use
Wipe the inside of the Refrigerator with warm water using a soft cloth. Wipe completely dry
before replacing any shelves or baskets.
Before Using Your Refrigerator
Check that you have your power outlet is compatible with the plug supplied with the
Refrigerator.
Always allow 2 hours before turning on the refrigerator to allow the coolant fluid time to settle
after the refrigerator is in place.
Before placing any food in your Refrigerator, turn the Refrigerator on and wait for 24 hours,
to make sure it is working properly and to allow the Refrigerator to fall to the correct
temperature.
Using Your Refrigerator
Switching on your Refrigerator:
1) Before connecting the Refrigerator to the mains supply make sure that the
Temperature Control located inside the Refrigerator is set between 3 and 4, which
is the correct setting for use in a room of average temperature.
2) Wait 24 hours before placing food in the cabinet to allow for the Refrigerator to fall
to the correct temperature.
Adjusting the Temperature
The internal temperature of your Refrigerator is controlled by the Temperature Control.
There are 6 settings. Position 6 makes the Refrigerator coldest. Position 1 makes it the
warmest. To adjust the temperature, turn the Temperature Control to the preferred setting.
The temperature of the Refrigerator is best maintained around 0
°
C to +5
°
C. Avoid setting
the thermostat too high otherwise this may reduce the temperature to a point where certain
fresh foods may begin to freeze.
Energy Saving Tips
•
Install the appliance in a fresh and well ventilated room. Ensure that the appliance is not in
direct sunlight and do not place near to heat sources.
•
Try to avoid keeping the door open for long periods or opening the door too frequently in
order to save energy.
•
Use the fridge on the highest temperature setting that is safe to do so.
•
Do not fill the appliance with too much food: cold air must be able to circulate freely for
food to be preserved properly.
•
Do not place hot food directly into the refrigerator. The internal temperature will increase
and force the compressor to work harder and will consume more energy.
4
1. Door hinge cap
2. Door hinge screws
3. Top door hinge
4. Door
5. Top hinge screw cap
6. Hinge plug (Door
frame)
7. Levelling front leg
8. Levelling front leg
9. Door hinge screws
10. Bottom hinge screws
