6
OPERATING INSTRUCTIONS
Inspection before operation
1. Check that the power cord is not damaged or fractured.
2. Please verify the rated current of the power socket is in line with the requirements on the rating label and
is equipped with a safety grounding device before use; otherwise, replace the socket.
Start and Power Selection
1.Start
•
Plug in the power and turn the thermostat knob clockwise to the “+” mark position.
•
Turn on the power switch and the heater will begin to operate.
2.Power Selection
Under normal circumstances please use the maximum power “III” gear for rapid heating. If the room
temperature reaches a suitable temperature, please choose a lower power “II” or “I” gear to reduce energy
consumption and to prevent the room becoming overheated.
Inspection method
Insert the power plug into the socket and turn the heater on. After about half an hour turn off and pull out the
plug. Check whether the plug pins are hot. Replace the socket if it is more than about 50 °C to avoid burning
the plug or causing a fire caused by overheating of the socket due to poor contact.
Temperature adjustment
During use, if you feel it is necessary to lower the room temperature since it is too high, you can use the
following adjustment modes:
1. Turn the power switch to gear “II” or “I”.
2. Turn the thermostat knob counterclockwise to set the temperature lower. The temperature is lower
when the indication is closer to the “ - ” position.
Stop
Turn the power switch to point “0” and then pull out the power plug.
Movement of the heater
To move the heater, turn it off first, and pull out the power plug; then push the body using the four casters at
the bottom of the unit.
