7
1. Take the unit out of the box, removing any packaging.
2. Insert the base of the extension pole into the top of the cross base
connector (the side without the grooves). (Fig.1)
3. Insert the 4 stand feet into the cross base connector. The feet should have
the flat edge facing the floor. Ensure that these are securely fitted. (Fig.2)
4. Loosen the height adjustment nut on the extension pole and extend (pull up)
the internal pole to the desired height. (Note: If the internal pole has slid into
the extension pole, gentle tilt the assembly until it slides out. Seek assistance
when doing this.) Fasten the height adjustment nut. (Fig.3 & 4)
5. To attach the head unit to the internal pole, loosen the thumb screw at
the base (the opposite end to the motor shaft). Place the head unit on the
internal pole and tighten the thumb screw when it is aligned with the groove
on the internal pole. (Fig.5)
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
The extension
pole correctly
inserted into the
cross base connector
Height
Adjustment Nut
Pole
Cross Base
Connector
Cross Base
Connector
Stand
Tighten
Tighten
Extend
Thumb
Screw
Internal Pole
Groove
