IFM SmartPLC DataLine AC1423, Device Manual

Page: 92 / 200

SmartPLC DataLine with EtherNet/IP device interface
92
>
Set the configuration mode
41650
More information:
→
Configuration mode
(
→ S.
193 )
To set the configuration mode of the device:
1 Select the menu page
►
> >
► Select [Fieldbus] tab.
2 Select the configuration method for the EtherNet/IP parameters
> Set the following parameter as required:
Parameter Description Possible values
[Configuration mode] Active configuration mode of
the device [Top-Down ] The device-specific parameters and the module
configuration are set via the projection software
of the EtherNet/IP controller.
[
Independent] The parameters of the EtherNet/IP interface are
set via the graphical user interface of the device.
3 Save the changes
> Press [Accept] button.
> Selected value is applied.
>
Set the device-specific parameters
41642
The parameters can only be changed if the configuration mode is set to
Independent
(
→
Set
the configuration mode
(
→ S.
92 )).
To set the device-specific parameters: set the number of channels to be transmitted per analogue
input slave:
1 Select the menu page
► > >
►
Select [Parameter] tab.
2 Set the number of analogue channels per input slave
► Set the following parameter as required:
Parameter Description Possible values
[Analog. channels/I-slave] Number of analogue
channels transmitted per
input slave [1 channel per A/B] 1 channel per A/B slave
OR:
channels 1 + 3 per single slave
[1 channel] 1 channel per single slave
OR:
1 channel per A slave
[2 channels] 2 channels per single slave
OR:
2 channels per A slave
[4 channels] 4 channels per single slave
OR:
2 channels per A/B slave