SmartPLC DataLine with EtherNet/IP device interface
70
>
Set the device cycle
41649
NOTICE!
A device cycle that is too short can have undesirable effects on the correct transmission of
the process and control data between the PLC and peripheral devices (higher-level PLC, AS-i
slaves).
>
Risk of material damage to the machine/plant!
► Ensure a sufficiently long cycle time!
If the PLC is disabled, the device operates with a fixed cycle time of
0.7 ms
.
To set the device cycle:
1 Select the menu page
►
>
►
Select [System settings] tab.
2 Set the device cycle
►
Set the following parameters as required:
Parameter
Description
Possible values
[Device cycle]
Active
→ device cycle
[1.5 ms]
1.5 milliseconds
[2.0 ms]
2.0 milliseconds
[2.5 ms]
2.5 milliseconds
[3.0 ms]
3.0 milliseconds
3 Save the changes
►
Press [Accept selection] button.
>
Selected value is applied.
