![background image](http://html.mh-extra.com/html/ifm/sd1540/sd1540_operating-instructions-manual_3943434043.webp)
43
UK
10.6.12 Error behaviour of the outputs
►
Select [FOU1] and set error behaviour for output 1:
switching output
-On
= output 1 switches ON in case of an error
-OFF = output 1 switches OFF in case of an error
-OU = output 1 switches irrespective of the error as defined with the
parameters
►
Select [FOU2] and set error behaviour for output 2:
switching output
-On
= output 1 switches ON in case of an error
-OFF = output 1 switches OFF in case of an error
-OU = output 1 switches irrespective of the error as defined with the
parameters
Analogue output
-On
= the analogue signal goes to the upper error value
-OFF = the analogue value goes to the lower error value
-OU = the analogue signal corresponds to the measured value
The parameter [FOUx] is not available if [ou] = Imp (consumed
quantity monitoring) was selected� The pulses are provided inde-
pendent of the fault�
Menu OUT1:
[FOU1]
Menu OUT2:
[FOU2]
10.6.13 Restore factory setting
►
Select [rES]�
►
Briefly press [
●]
]�
► Keep [▲] or [▼] pressed.
> [----] is displayed�
►
Briefly press [
●
]�
> The device carries out a reboot�
� We recommend taking down your own set-
tings in that table before carrying out a reset�
Menu EF:
[rES]