IFM O8H2, Operating Instructions Manual

Page: 8 / 9

8
7 IO-Link
7.1 General information
This unit has an IO-Link communication interface which requires an IO-Link-
capable module (IO-Link master) for operation� The IO-Link interface enables
direct access to the sensor values and parameters and provides the possibility
to set the parameters of the unit during operation� In addition communication is
possible via a point-to-point connection with a USB adapter cable�
You will find more detailed information about IO-Link at www�ifm�com/uk/io-link�
7.2 Device-specific information
You will find the IODDs necessary for the configuration of the IO-Link device and
detailed information about sensor values, diagnostic information and parameters
in the overview table at www�ifm�com/uk/io-link�
7.3 Parameter setting tools
You will find all necessary information about the required IO-Link hardware and
software (e�g� ifm LR DEVICE) at www�ifm�com/uk/io-link�
7.4 Setting parameters via IO-Link
Among others, the following parameters can be set via IO-Link�
A table of all adjustable parameters can be found at
www�ifm�com/uk/io-link�
IO-Link parameter name Parameter
SSC1 Param�SP1 Target value range
SSC1 Config�Logic
Switch point logic / status for the detected object
High active: light-on mode - normally open
Low active: dark-on mode - normally closed
(→ 8 Operation)
SSC1 Switch-On delay Switch-on delay
SSC1 Switch-Off delay Switch-off delay
Transmitter configuration Transmitted light ON / OFF
Sequence modulation Anti-crosstalk function ON / OFF
Teach SP1 TP1 / Teach SP1 TP2
Setting the range by means of object and
background