![background image](http://html.mh-extra.com/html/ifm/iocontrol-cr2050/iocontrol-cr2050_programming-manual_620709035.webp)
35
ifm
Programming Manual BasicController relay CR0431 v03.03.00
05 / 2018
Configurations
Set up the runtime system
>
4.1.1
Reinstall the runtime system
14635
8486
On delivery of the
ecomatmobile
controller no runtime system is normally loaded (LED flashes green
at 5 Hz). Only the boot loader is active in this operating mode. It provides the minimum functions for
loading the operating system (e.g. RS232, CAN).
Normally it is necessary to download the runtime system only once. The application program can then
be loaded to the device (also several times) without influencing the runtime system.
The runtime system is provided with this documentation on a separate data carrier. In addition, the
current version can be downloaded from the website of
ifm electronic gmbh
:
8651
NOTICE
Risk of data loss!
In case of power failure during the data transmission data can be lost so that the device is no longer
functionable. Repair is only possible by
ifm electronic
.
► Ensure an uninterrupted power supply during the data transmission!
8485
NOTE
The software versions suitable for the selected target must always be used:
• runtime system (
ifm_CR0431_Vxxyyzz.RESX
),
• PLC configuration (
ifm_CR0431_Vxx.CFG
),
• device library (
ifm_CR0431_Vxxyyzz.LIB
) and
• the further files.
V
xx: 00...99
yy: 00...99
zz: 00...99
version
target version number
release number
patch number
The basic file name (e.g. "
CR0431
") and the software version number "xx" (e.g. "
01
") must always have
the same value! Otherwise the device goes to the STOP mode.
The values for "yy" (release number) and "zz" (patch number) do
not
have to match.
4368
The following files must also be loaded:
• the internal libraries (created in IEC 1131) required for the project,
• the configuration files (
*.CFG
) and
• the target files (
*.TRG
).
It may happen that the target system cannot or only partly be programmed with your currently
installed version of CODESYS. In such a case, please contact the technical support department of
ifm
electronic gmbh
.
Contact
The runtime system is transferred to the device using the separate program "Maintenance Tool". (The
program can be downloaded from
ifm's
website, if necessary):
Normally the application program is loaded to the device via the programming system. But it can also
be loaded using the "Maintenance Tool" if it was first read from the device.
Summary of Contents for ioControl CR2050
Page 228: ...228 10 Notizen Notes Notes ...