IFM efector200 O6P2 Operating Instructions Manual Download Page 5

Page: 5 / 6

6 Settings

6.1 Set the output function

► Setting D: dark-on mode

► Setting L: light-on mode

6.2 Set the sensitivity

► Increase sensitivity: turn the setting

screw of the potentiometer clockwise.

► Decrease sensitivity: turn the setting

screw of the potentiometer anti-

clockwise.

7 Operation

► Check whether the unit operates correctly.

> The green LED is lit when the supply voltage is applied and there is sufficient

excess gain.

> Dark-on mode: the output is switched / the yellow LED is lit when an object is

detected.

> Light-on mode: the output is switched / the yellow LED is lit when no object is

detected.

Summary of Contents for efector200 O6P2

Page 1: ...Operating instructions Retro reflective sensor O6P2 O6P200 01 01 2015 UK ...

Page 3: ...ctor output function 4 1 Stability indication The green LED is lit when the supply voltage is applied and there is sufficient excess gain Under these conditions the sensor receives a stable signal stable signal switch point stable signal Light on mode LED green on off off on LED yellow on on off off Dark on mode LED green on off off on LED yellow off off on on ...

Page 4: ...e adhered to Ensure voltage supply to EN 50178 Disconnect power Connect the unit as follows 5 1 PNP Connector M12 pigtail Cable Connector M8 3 pin Connector M8 4 pin 2 1 4 3 Core colours BN brown BU blue BK black 5 2 NPN Connector M12 pigtail Cable L L 1 4 3 L BN BK BU L Connector M8 3 pin Connector M8 4 pin L L 1 4 3 2 1 4 3 L L 1 4 3 Core colours BN brown BU blue BK black ...

Page 6: ...ny solvents or cleaning agents which could damage the plastic parts After use dispose of the unit in an environmentally friendly way in accordance with the applicable national regulations Faulty sensors must only be repaired by the manufacturer Technical data and further information at unter www ifm com ...