Set-up
Device-specific Profibus DP parameters
7-26
7.4.2
Definitions in the GSD file
The definitions in the GSD file (GSD =
G
eneral
S
tation
D
escription) enable easy access to the device
parameters if this is supported by the configuration tool of the Profibus DP master:
Example
Siemens Step 7
Byte 37
Bit 5 = TRUE
If the parameter "Extended Profibus Diag." is set to "Enabled", the controllere transmits the extended
diagnostic data described in the next section. This data generates a DP request for a diagnosis in
case of an error state in the controllere. Therefore for a Siemens PLC OB82 must be programmed to
react to this state, otherwise the PLC stops.
Summary of Contents for Ecomat 300 AC1355
