Universal display
DX1063
33
10 Operation
After switching the supply voltage on, the unit displays the software version for 3 seconds. Then the
unit switches into operating mode. Display indications correspond to the parameter setting.
Alarms are visually reported in the display via a colour change of the background and font. A display
overflow is displayed via [OL], a display underflow via [UL] (if configured).
Switched-on relays are displayed as follows:
1
Relay 1 switched on
2
Relay 2 switched on
In operating mode, the keys can be used to perform the following functions:
Key
Function
[esc]
Special function for voltage, current and frequency measurements:
Hold down < 1 s to perform taring (offset), if configured.
This function tares the current display to zero and stores it as an offset. The value is lost when the unit is restart-
ed.
[▲]
Display the maximum value or change the upper limit value (depending on the key function configured)
[▼]
Display the minimum value or change the lower limit value (depending on the key function configured)
[▲] + [▼]
Hold down < 1 s to exit the maximum/minimum value display.
[●]
Hold down > 1 s → Change to parameter setting mode
