IO-Link Master with AS-Interface Interface StandardLine 2 Ports IP 65 / IP 66 / IP 67
34
10
Maintenance, repair and disposal
Content
Cleaning process ....................................................................................................................................34
Replacing IO-Link device ........................................................................................................................34
51990
The operation of the unit is maintenance-free.
►
Dispose of the unit in an environmentally friendly way in accordance with the applicable national
regulations when it is no longer used.
>
10.1 Cleaning process
51991
►
Clean the surface of the unit when necessary.
►
Do not use any caustic cleaning agents for this!
>
10.2 Replacing IO-Link device
34182
To replace an IO-Link device:
Requirement:
>
New IO-Link device is with factory settings.
>
New IO-Link device supports IO-Link standard 1.1 or higher.
1 Set data storage
►
Set the following parameters of the IO-Link port
Set Validation and Data Storage to [Type compatible V1.1 device with Restore] or [Type compatible V1.1. device
with Restore]
Set correct values to [Vendor ID] and [Device ID] according to properties of the IO-Link device.
►
Save changes.
2 Replace IO-Link device
►
Disconnect old IO-Link device from IO-Link master.
►
Connect new IO-Link device with the same IO-Link port of the AC6002.
>
IO-Link master copies parameter values from the data memory to the new IO-Link device.
