O System setup
(Setting of the controller
e
device)
∇
Baud rate of the serial programming interface
∇
IP address of the Ethernet programming interface
(optional)
∇
Input of the password to enable changes in the
system configuration
∇
Update of the controller
e
firmware (special pro
gramming software required)
O System info
(Device information)
∇
Hardware and firmware version numbers of this
controller
e
∇
Serial number of this controller
e
∇
Current /maximum PLC cycle time
O PLC setup
(Use of the integrated PLC is optional)
∇
Activation or deactivation of the gateway mode
(no PLC used)
∇
Start or stop of the PLC in the controller
e
(if used)
O PLC info
(Display of the user program name, author, date)
O Master setup
(AS-i master flags)
∇
Reading of the current AS-i configuration (Config
all)
∇
Changeover to the projection mode: configuration
of the AS-i system
∇
Changeover to the protected mode: standard
mode (the master monitors the configuration)
∇
Deactivation of the automatic AS-i slave addres-
sing in the protected mode
∇
Deactivation of the AS-i reset when exiting the
projection mode
∇
Display of the config error counter of the connec-
ted AS-i system
∇
Reset of the config error counter
∇
Display of the percentage fault rate of the
connected AS-i system
PAGE
14
