PROBLEM SOLVING
s
Fault
symptom
Cause analysis
Troubleshooting
The
appliance
does not
respond
when any of
the buttons
are pressed.
The Power Cable could be
damaged.
Please stop use and contact
customer service.
AC Fuse could be damaged
or the circuit stops
functioning to prevent
overload.
Replace the Fuse or restart the
unit. If problems persist, please
stop use and contact customer
service.
Remote Control or Control
Panel could be damaged.
Contact customer service to
replace the Remote Control or
to repair the Control Panel.
Remote Control batteries
have run out.
Replace the Remote Control
batteries.
The overflow indicator
displays "FULL".
Drain the water from the Water
Pan (refer to section on “How to
Drain”).
The ambient temperature is
too low or too high.
Use the appliance between 7 –
35
°
C
℃
(44 – 95
°
F).
In COOL mode, the room
temperature is lower than
the set temperature.
Decrease the set temperature.
In DEHUMIDIFY mode, the
ambient temperature is low.
Place the appliance in a room
with an ambient temperature
greater than 17
°
C (62
°
F).
No air flows
out of the
appliance
while the
appliance is
operating.
The Compressor could be
damaged.
Please stop use and contact
customer service.
The wiring within the
Compressor or appliance
could have loosened.
Please stop use and contact
customer service.