IER i420
User Safety and Start Guide
Ce document est la propriété d'IER et ne doit pas être reproduit ou communiqué sans autorisation écrite
This document is the property of IER and may not be reproduced or communicated without prior written authorization.
Page 4
N0L8S2A6 P1
SAFETY INSTRUCTIONS
WHICH MUST BE STRICTLY OBSERVED!
To prevent personal injury or property damage, the following shall be strictly observed.
The degree of possible injury and damage due to incorrect use or improperly following instructions is described below.
INDICATES A SITUATION WHICH, IF NOT OBSERVED AND HANDLED PROPERLY, COULD RESULT IN
DEATH OR SERIOUS INJURY.
Indicates a situation which, if not observed and handled properly, could result in injury.
Warns against the presence of hot surfaces. Do not touch. To prevent skin burn injuries, turn off, unplug
and allow surfaces to cool down before servicing.
Warns against the risk of hand cuts or hand crushing. To prevent injuries, turn off, unplug and wear
gloves during servicing.
NEVER PERFORM THE FOLLOWING. IF NOT AVOIDED, THESE MAY CAUSE DAMAGE OR TROUBLE TO
THE PRINTER OR CAUSE THE PRINTER TO OVERHEAT AND RELEASE SMOKE AND CAUSE BURNS
OR AN ELECTRICAL SHOCK. IF THE PRINTER IS DAMAGED OR IS MALFUNCTIONING, BE SURE TO
TURN THE PRINTER OFF IMMEDIATELY AND REMOVE THE POWER CORD FROM THE OUTLET, THEN
CONSULT OUR SERVICE PERSONNEL.
DO NOT JOLT OR IMPACT TO THE PRINTER BY STEPPING ON, DROPPING OR HITTING THE
PRINTER.
DO NOT PLACE THE PRINTER IN A POORLY VENTILATED AREA, OR SHUT OFF THE AIR VENT OF
THE PRINTER.
DO NOT PLACE THE PRINTER WHERE CHEMICAL REACTIONS OCCUR, SUCH AS IN
LABORATORIES OR WHERE AIR IS
MIXED WITH SALT OR GAS.
DO NOT USE A POWER VOLTAGE OR FREQUENCY OTHER THAN THOSE SPECIFIED.
DO NOT PLUG/UNPLUG THE POWER CORD OR ATTACH/DETACH THE INTERFACE CABLE BY
SIMPLY GRABBING THE POWER CORD OR INTERFACE CABLE. DO NOT PULL OR CARRY THE
PRINTER WHEN THE TENSION OF THE POWER CORD OR INTERFACE CABLE IS INCREASED.
DO NOT DROP OR PUT FOREIGN MATTER SUCH AS CLIPS AND PINS INTO THE PRINTER. THIS
MAY CAUSE PROBLEMS.
DO NOT PLUG THE POWER CORD INTO AN OUTLET WITH MANY LOADS.
DO NOT SPILL DRINKS SUCH AS TEA, COFFEE AND JUICE ON THE PRINTER OR SPRAY
INSECTICIDE ON THE PRINTER. IF DRINK OR WATER IS SPILLED, FIRST BE SURE TO TURN THE
POWER OFF AND REMOVE THE POWER CORD FROM THE OUTLET, THEN CONSULT OUR SERVICE
PERSONNEL.
DO NOT DISASSEMBLE OR MODIFY THE PRINTER.
THE PRINTER IS NOT TRANSPORTABLE.
NOTICE
Before use, be sure to read this manual. And keep it handy for reference when needed.
The contents of this manual may change without prior notice.
Reproduction, transfer, or transmission of the contents of this manual without prior consent is strictly prohibited.
We are not liable for any damage resulting from the use of the information contained herein, regardless of errors,
omissions, or misprints.
We are not liable for any problems resulting from the use of optional products and consumable supplies other than the
designated products contained herein.
Do not handle, disassemble or repair the parts other than those specified in this manual.
We are not liable for any damage caused by user's erroneous use of the printer and inadequate environment.
Data residing in the printer is temporary. Therefore, all data will be lost if power is lost. We are not liable for any
damage or loss of profits caused by data loss due to failures, repairs, inspections, etc.
Please contact us if there are any mistakes or ambiguities within this manual.
If there are missing or incorrectly collated pages in this manual, contact us to obtain a new manual.
PROVISOIRE
