Memory
31
EN
8.2
Deleting readings from the blood pressure
monitor
To clear the memory on your blood pressure monitor,
proceed as follows:
Fig. 11: Delete measurements
1) Press and hold the
button on the blood
pressure monitor for about 3 seconds.
The display shows
[IP]
(see Fig. 11A).
Note
Every 3 seconds, the display will automatically
display the next menu option. The display order
is:
Infrared transmission (IR)
Bluetooth
®
transmission (BT)
Active pairing (PAI A)
Passive pairing (PAI P)
Delete readings (c lr)
Note
The Infrared transmission (IR) menu option is
intended for service personnel only.
2) Wait until
[c lr]
flashes on the display (Fig. 11 C).
3) Press the
button.
You will hear an acoustic signal and the display
will be shown
[c lr]
permanently.
Summary of Contents for Tel-O-Graph BT plus
Page 1: ...Operating manual EN Tel O Graph BT plus ...
Page 51: ...Rev A 18 12 2018 ...
