3
—
cut off the necessary length of wire. To do this, use the cutting module
built into the stripper;
IT IS FORBIDDEN
—
set the desired stripping length with the regulator;
—
place the wire in the stripper so that the wire rests on the stripping length
regulator, press the movable handle to strip a section of insulation
;
Installation and operation rules
To cut wires and/or to strip insulation from live wires.
To use the stripper for anything other than its intended use
(as a lever, percussive tool tool, etc.).
Violation of rules of safety regulations during work may cause injuries
and damage to the stripper.
Safety precautions
Installation work should only be performed with a properly operating stripper.
The product should be carefully inspected before each use. The stripper should
be free of cracks, handle damage, deformation and dents on the stripper blade.
Handles should be clean and dry, with no traces of oil or grease.
ATTENTION
Operating manual:
—
remove the stripper from the package;
Basic product data
The overall dimensions of the stripper are shown in the figure 1.
Completeness of set
The product delivery set is shown in the table 2.
À
S 0,03–10 automatic stripper of MASTER series of IEK trademark
(hereinafter - stripper) is designed for stripping and cutting wires.
Technical data
The main technical characteristics of the tool are given in the table 1.
EN
AS 0,03-10 AUTOMATIC STRIPPER OF MASTER SERIES
