IEI Technology WSB-H610, User Manual, Page: 66 / 187

WSB-H610 PICMG 1.0 CPU Card
Page 51
Step 5: Connect the fan cable . Connect the cooling kit fan cable to the fan connector
on the WSB-H610. Carefully route the cable and avoid heat generating chips
and fan blades.
4.2.3 DIMM Installation
To install a DIMM, please follow the steps below and refer to Figure 4-6 .
Figure 4-6: DIMM Installation
Step 1: Open the DIMM socket handles . Open the two handles outwards as far as
they can. See Figure 4-6 .
Step 2: Align the DIMM with the socket . Align the DIMM so the notch on the memory
lines up with the notch on the memory socket. See Figure 4-6 .
Step 3: Insert the DIMM . Once aligned, press down until the DIMM is properly seated.
Clip the two handles into place. See Figure 4-6 .
Step 4: Removing a DIMM . To remove a DIMM, push both handles outward. The
memory module is ejected by a mechanism in the socket.