IEI Technology WAFER-US15WP, User Manual

Page: 48 / 94

WAFER-US15WP 3.5" SBC
Page 38
Pin Description
1-2 Keep CMOS Setup
2-3 Clear CMOS Setup
Table 4-2: Clear CMOS Jumper Settings
4.3.2 AT/ATX Mode Selection
Jumper Label: AT/ATX1
Jumper Type: 2-pin header
Jumper Settings: See Table 4-3
Jumper Location: See Figure 4–1
Set both of the jumpers select AT or ATX power mode for the WAFER-US15WP. AT
power mode limits the system to on/off. ATX allows the system to use various power
saving states and enter a standby state, so the system can be turned on remotely over a
network. The settings on both jumpers should be the same.
Pin Description
Short ATX mode
Open AT mode
Table 4-3: AT/ATX Mode Selection
4.3.3 LVDS Voltage Selection
Jumper Label: JP1
Jumper Type: 3-pin header
Jumper Settings: See Table 4-4
Jumper Location: See Figure 4–1
Selects the voltage of the LVDS connector.
Pin Description
1-2 3.3 V