IEI Technology WAFER-ULT3, User Manual

Page: 71 / 136

WAFER-ULT3/ULT4 3.5" SBC
Page 57
4.6.5 LVDS Voltage Selection
WARNING:
Permanent damage to the screen and WAFER-ULT3/ULT4 may occur
if the wrong voltage is selected with this jumper. Please refer to the
user guide that came with the monitor to select the correct voltage.
Jumper Label: JP1
Jumper Type:
3-pin header, p=2 mm
Jumper Settings: See
Table 4-4
Jumper Location: See
Figure 4-12
The LVDS voltage selection jumper allows setting the voltage provided to the monitor
connected to the LVDS connector.
Setting Description
Short 1-2 +3.3V LVDS (Default)
Short 2-3 +5V LVDS
Table 4-4: LVDS Voltage Selection Jumper Settings
Figure 4-12: LVDS Voltage Selection Jumper Location