IEI Technology WAFER-PV-N4552, User Manual

Page: 55 / 116

WAFER-PV-D5252/D4252/N4552 SBC
Page 43
Before and during the installation of the WAFER-PV-D5252/D4252/N4552 DO NOT:

DO NOT remove any of the stickers on the PCB board. These stickers are
required for warranty validation.

DO NOT use the product before verifying all the cables and power connectors
are properly connected.

DO NOT allow screws to come in contact with the PCB circuit, connector pins,
or its components.
4.3 SO-DIMM Installation
To install an SO-DIMM, please follow the steps below and refer to Figure 4-1.
Figure 4-1: SO-DIMM Installation
Step 1: Locate the SO-DIMM socket . Place the board on an anti-static mat.
Step 2: Align the SO-DIMM with the socket . Align the notch on the memory with the
notch on the memory socket.
Step 3: Insert the SO-DIMM . Push the memory in at a 20º angle. (See Figure 4-1)
Step 4: Seat the SO-DIMM . Gently push downwards and the arms clip into place. (See
Figure 4-1)