IEI Technology WAFER-PV-D5252, User Manual

Page: 71 / 142

WAFER-PV-D5252/D4252/N4552 SBC
Page 58
Figure 4-16: LAN Connection
Step 3: Insert the LAN cable RJ-45 connector. Once aligned, gently insert the LAN
cable RJ-45 connector into the on-board RJ-45 connector. Step 0:
4.8.2 Serial Device Connection
The WAFER-PV-D5252/D4252/N4552 has a single female DB-9 connector on the
external peripheral interface panel for a serial device. Follow the steps below to connect a
serial device to the WAFER-PV-D5252/D4252/N4552.
Step 1: Locate the DB-9 connector . The location of the DB-9 connector is shown in
Chapter 3 .
Step 2: Insert the serial connector . Insert the DB-9 connector of a serial device into
the DB-9 connector on the external peripheral interface. See Figure 4-17.