IEI Technology WAFER-BT, User Manual

Page: 66 / 114

WAFER-BT
P a g e 54
To install these devices, connect the corresponding cable connector from the actual
device to the corresponding WAFER-BT external peripheral interface connector making
sure the pins are properly aligned.
4.6.1 LAN Co n n e c tio n
There is one external RJ-45 LAN connector on the external peripheral interface panel. The
RJ-45 connector enables connection to an external network. To connect a LAN cable with
an RJ-45 connector, please follow the instructions below.
S te p 1:
Locate the RJ-45 connector . The location of the LAN connector is shown in
Chapter 3 .
S te p 2:
Align the connector. Align the RJ-45 connector on the LAN cable with the
RJ-45 connectors on the WAFER-BT. See Figure 4-10 .
Figure 4-10: LAN Connection
S te p 3:
Insert the LAN cable RJ-45 connector. Once aligned, gently insert the LAN
cable RJ-45 connector into the on-board RJ-45 connector.