IEI Technology WAFER-BT, User Manual

Page: 65 / 114

WAFER-BT
P a g e 53
S te p 2:
Insert the cable connector . Insert the connector into the serial port box header.
See Figure 4-9. A key on the front of the cable connectors ensures the
connector can only be installed in one direction.
Figure 4-9: Single RS-232 Cable Installation
S te p 3: Secure the bracket . The single RS-232 connector has two retention screws
that must be secured to a chassis or bracket.
S te p 4: Connect the serial device . Once the single RS-232 connector is connected to
a chassis or bracket, a serial communications device can be connected to the
system.
4.6 Exte rn a l P e rip h e ra l In te rfa c e Co n n e c tio n
The following external peripheral devices can be connected to the external peripheral
interface connectors.

RJ-45 LAN cable

Serial port devices

USB devices

VGA monitor