IEI Technology WAFER-BT, User Manual

Page: 56 / 114

WAFER-BT
P a g e 44
4.3 S O-DIMM In s ta lla tio n
WARNING:
Using incorrectly specified SO-DIMM may cause permanently damage
the WAFER-BT. Please make sure the purchased SO-DIMM complies
with the memory specifications of the WAFER-BT. SO-DIMM
specifications compliant with the WAFER-BT are listed in the
specification table of Chapter 1.
To install an SO-DIMM, please follow the steps below and refer to Figure 4-1.
Figure 4-1: SO-DIMM Installation
S te p 1:
Locate the SO-DIMM socket . Place the board on an anti-static mat.
S te p 2: Align the SO-DIMM with the socket . Align the notch on the memory with the
notch on the memory socket.
S te p 3: Insert the SO-DIMM . Push the memory in at a 20º angle. (See Figure 4-1)
S te p 4:
Seat the SO-DIMM . Gently push downwards and the arms clip into place. (See
Figure 4-1)