IEI Technology WAFER-AL, User Manual

Page: 34 / 139

WAFER-AL SBC
Page 20
3.2.3 Battery Connector
CAUTION:
Risk of explosion if battery is replaced by an incorrect type. Only
certified engineers should replace the on-board battery.
Dispose of used batteries according to instructions and local
regulations.
NOTE:
It is recommended to attach the RTC battery onto the system chassis
in which the WAFER-AL is installed.
CN Label:
BT1
CN Type:
2-pin wafer, p=1.25 mm
CN Location:
See Figure 3-5
CN Pinouts:
See Table 3-5
The battery connector is connected to the system battery. The battery provides power to
the system clock to retain the time when power is turned off.
Figure 3-5: Battery Connector Location