IEI Technology WAFER-945GSELVDS2-N270-R10, User Manual

Page: 76 / 140

WAFER-945GSELVDS2
Page 64
4.9.2 Serial Device Connection
The WAFER-945GSELVDS2 has a single female DB-9 connector on the external
peripheral interface panel for a serial device. Follow the steps below to connect a serial
device to the WAFER-945GSELVDS2.
Step 1: Locate the DB-9 connector . The location of the DB-9 connector is shown in
Chapter 3 .
Step 2: Insert the serial connector . Insert the DB-9 connector of a serial device into
the DB-9 connector on the external peripheral interface. See Figure 4-18.
Figure 4-18: Serial Device Connector
Step 3: Secure the connector . Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector .
Step 0:
4.9.3 USB Connection (Dual Connector)
The external USB Series "A" receptacle connectors provide easier and quicker access to
external USB devices. Follow the steps below to connect USB devices to the
WAFER-945GSELVDS2.