8
2.3 Unpacking
Your WAFER-6820 Single Board Computer contains sensitive
electronic components that can be easily damaged by static
electricity.
In this section, we describe the precautions you should take while
unpacking, as well as during installation. It is very important that the
instructions be followed correctly, to avoid static damage, and to
successfully install the board.
The system board should be done on a grounded anti-static mat.
The operator should be wearing an anti-static wristband, grounded
at the same point as the anti-static mat.
Inspect the cardboard carton for obvious damage. Shipping and
handling may cause damage to your board. Be sure there are no
shipping and handing damages on the board before processing.
After opening the cardboard carton, exact the system board and
place it only on a grounded anti-static surface component side up.
Again inspect the board for damage. Press down on all the
docketed IC's to make sure that they are properly seated.
Do this only with the board place on a firm flat surface.
Note: DO NOT APPLY POWER TO THE BOARD IF IT HAS BEEN
DAMAGED.
You are now ready to install your WAFER-6820 Single Board
Computer.
Summary of Contents for WAFER-6820
Page 10: ...6...
Page 11: ...7 2 2 WAFER 6820 DIMENSION...