IEI Technology uIBX-230-BT Series, User Manual

Page: 29 / 96

u IBX-230-BT Em b e d d e d S ys te m
P a g e 20
S te p 1:
Locate the DB-9 connector . The locations of the DB-9 connectors are shown
in Chapter 1 .
S te p 2:
Insert the serial connector . Insert the DB-9 connector of a serial device into
the DB-9 connector on the uIBX-230-BT. See Figure 3-11.
Figure 3-11: DB-9 Serial Port Connector
S te p 3:
Secure the connector . Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
S tep 0:
3.8.4 US B De vic e Co n n e c tio n
NOTE:
User must install the USB 3.0 driver before connecting a USB device to
the system or else the system may not recognize the connected
device.